Home care
Where are the water, power and gas shut-offs?
Most homes have a main water shut-off, a small valve at each sink, toilet and water heater, and an electrical panel. In a leak, close the water main first. If you smell gas, do not look for a valve: leave and call 911.
Key points
- Find your water main in your first week, before you need it. Take a photo of it.
- To close a round handle, turn it clockwise until it stops. A lever handle closes with a quarter turn. Do not use tools to force either.
- Small valves under sinks and behind toilets stop one fixture without shutting off the whole home.
- At the electrical panel you may reset a tripped breaker once. Never open the panel’s inner cover.
- Residents do not turn gas valves or gas meters. A gas smell means leave and call 911.
- The valve at the water meter or in the street is not yours to turn.
Stop and call
- Call 911 for a gas smell or fire. Leave first and call from outside.
- Call 911 if water is reaching outlets, light fixtures or the electrical panel. Stay away from them and leave the home.
- Call us if a valve will not close, or water keeps coming after you close the main.
Call (509) 525-1040, Monday to Friday, 9:00 AM to 4:00 PM. The same number is for after-hours property emergencies.
Where are the shut-offs?
Homes differ, so the table shows where to look. Check your move-in checklist and any notes you were given at move-in. If you cannot find one, ask us at (509) 525-1040 during office hours, and do not wait for a leak to find out.
| Shut-off | Where to look | What you may do |
|---|---|---|
| Water main | Where the water line enters the home, such as a garage, utility room or basement. In some homes it is outside in a box near the foundation. | Close it in a leak. Open it again once the cause is fixed. |
| Fixture valves | Under sinks, behind toilets, behind the washer. | Close the valve for the one fixture that is leaking or running. |
| Water heater valve | A valve on the cold water pipe going into the top of the tank. | Close it if the heater is leaking, then call us. Do not touch the gas valve or controls. |
| Electrical panel | A gray metal box in a hallway, garage, utility room or closet, with a door that opens to a row of switches. | Reset a tripped breaker once. Do not open the inner cover. |
| Furnace switch | A wall switch near the furnace, if your home has one. | Check that it is on. Do not open the furnace. |
| Gas valve or meter | Leave it alone. Do not look for it. | Nothing. Leave and call 911 for a gas smell. |
| Water meter and street valve | A box in the ground near the street or the edge of the lot. | Nothing. It belongs to the water utility. Call your city’s water department about a leak there. |
If a shut-off is somewhere you cannot reach from a normal standing position, such as a crawl space or an attic, do not climb or crawl in. Call us.
How do I close the water main?
- Find the handle. A round wheel closes clockwise. A lever handle is closed when it sits across the pipe, a quarter turn from open.
- Turn it until it stops. Do not use a wrench or pipe to force a stuck valve. If it will not move, stop and call us.
- Open the lowest faucet in the home to let the water in the pipes drain.
- Call us at (509) 525-1040, and take photos of the damage.
- Move belongings away from the wet area.
Leave the main closed while water is still escaping. Once the cause is fixed, open the valve slowly and check for drips. If you are not sure it is fixed, leave it closed and call us.
How do I stop one fixture?
Close the small valve under the sink or behind the toilet by turning it clockwise. If a toilet is running or rising, close its valve first, then lift the tank lid and look at the flapper.
How do I read the electrical panel?
- Labels: each switch (breaker) has a label on the panel door or beside it, such as “kitchen” or “bedroom.” If a label is missing or wrong, tell us.
- Tripped: a tripped breaker sits in the middle, between on and off, or shows a colored flag. A breaker that is off sits all the way to one side.
- Reset once: push a tripped breaker fully to off, then fully to on. If it trips again at once, do not reset it again. Submit a request, or call us if you see sparks or smell burning.
- GFCI outlets: outlets in kitchens, baths, garages and outdoors often have TEST and RESET buttons. If the outlet is dead, press RESET.
- Main breaker: the large switch at the top or bottom of the panel. If it has tripped, reset it once, the same way. If there is water near the panel, stay away from it and call 911.
- Inner cover: never remove it, touch wiring or replace a breaker.
What about gas?
We do not ask residents to turn off a gas valve, work on a gas appliance or relight a pilot. If you smell gas, which smells like rotten eggs, leave, take everyone with you and call from outside. The full steps are on Emergency or urgent? What to do and who to call.
How do I learn where mine are?
- Read your move-in checklist and any notes you were given at move-in.
- In your first week, walk the home and find the water main, the fixture valves, the electrical panel and the furnace switch.
- Photograph each one, with a wider photo showing where it is, and save the photos on your phone.
- Tell everyone in the household where the water main is.
Questions and answers
What if a valve will not turn?
Stop. Do not use tools to force it. Call us at (509) 525-1040. If water is escaping, close any smaller valve you can reach and move belongings away.
Can I turn the water back on?
Not while water is still escaping. After the cause is fixed, open the valve slowly and check for drips. If you are not sure it is fixed, leave it closed and call us.
Who do I call for a leak in the street?
Your city’s water department. Do not turn the valve at the meter or in the street. Then tell us.
May I turn off the gas?
No. If you smell gas, leave and call 911 from outside. Do not look for a valve.
Last reviewed: .
This page is general information, not legal advice. The lease you signed and Washington law control. If anything here differs from your lease, your lease controls.