Home care
Something broke: what to try before you submit a repair request
Many common problems, like a tripped breaker or a clogged toilet, take a few minutes to fix with the steps below. If a step does not work, or the problem is on the “stop and call” list, submit a request in the resident portal, or call us if it is an emergency.
Key points
- Try only the steps on this page. None of them asks you to take a cover off equipment or work on gas.
- Reset a tripped breaker once. If it trips again at once, stop and submit a request.
- Never put a hand in a garbage disposal, open the inner cover of the electrical panel, relight a pilot, or climb a ladder.
- Report repairs through the resident portal, where you can attach photos.
- For an emergency, call (509) 525-1040. Call 911 first if anyone is in danger.
- We handle repairs to the home’s systems and normal wear. Everyday care, and damage that you or your guests cause, are yours. Your lease has the details.
Stop and call us
- Call 911 for a gas smell, smoke or fire, a carbon monoxide alarm, sparks, or a strong burning smell. Leave first.
- A breaker that trips again as soon as you reset it.
- Water that will not stop, a ceiling stain with water behind it, or sewage coming up a drain.
- Anyone hurt, or anything you are not sure is safe.
Call (509) 525-1040, Monday to Friday, 9:00 AM to 4:00 PM. The same number is for after-hours property emergencies. For what counts as an emergency, see Emergency or urgent? What to do and who to call.
Which problem do you have?
- Water: toilet, slow or blocked drain, dishwasher, garbage disposal, no hot water, dripping faucet
- Power: dead outlet, part of the home dark, whole home dark, lights
- Heat and air: no heat, no cooling or a blank thermostat
- Appliances: refrigerator, range or oven, washer or dryer, garage door
- Doors and windows: sticking or will not lock
- A chirping alarm
- A problem that is not on this list
Water problems
The toilet will not flush, or is blocked
- Look at the water level in the bowl. If it is nearly full, do not flush. If it is low, flush once to see whether it clears. Avoid flushing again while it is blocked, because that can make it overflow.
- If the water is rising, close the small valve on the wall behind the toilet. Turn it clockwise.
- Plunge slowly. Use a plunger with a flange, press down gently and pull back, and keep going so the blockage is pumped through gradually.
- Flush once to check. If it drains, open the valve again if you closed it, and you are done. If it does not drain, leave the valve closed and submit a request.
No blockage, but the flush does not work? Lift the lid off the tank and set it aside. Check that the chain is attached to the handle arm and to the flapper at the bottom, and that the flapper closes over the drain opening. If the toilet keeps running, jiggle the handle once and check the flapper.
A sink, tub or shower drains slowly or not at all
- Remove the stopper or strainer and clear any hair and debris you can see.
- Plunge with a cup plunger. Cover a sink’s overflow opening with a damp cloth first.
- Run hot water for a minute to see whether the drain clears.
Do not use chemical drain cleaners. They can damage pipes, can burn skin, and make a later repair less safe. If the plunger does not clear it, submit a request. Clearing a minor drain stoppage is the resident’s job. Your lease says who pays when a drain needs professional cleaning or causes water damage.
The dishwasher will not drain
- Check that the kitchen sink drains. A blocked sink will hold dishwasher water.
- Open the dishwasher and look at the filter or strainer in the bottom. Clear any food and debris.
- Run a short cycle. If water still stands in the bottom, submit a request.
The garbage disposal hums or will not run
Switch it off at the wall switch. Never put your hand in a disposal, even when it is off. If it makes no sound at all, press the small red reset button on the bottom of the unit once, then try the switch again. If it hums, or still will not run, leave it off and submit a request. See the kitchen and laundry guide for what may go down a disposal and a drain.
There is no hot water
- Check more than one hot tap. If only one tap is cold, tell us which one.
- Look at the control on the outside of the water heater, without touching it. If it is set to off, pilot or vacation, say so in your request.
- If the heater is electric, check the breaker in the electrical panel. Reset it once if it has tripped.
- Wait about an hour, then test the hot water again. A tank takes time to heat.
- If there is still no hot water, submit a request. It is urgent, so add “no hot water” at the start of your description.
Do not remove any cover from a water heater. Do not touch the gas valve or relight a pilot on a gas heater. If you smell gas, leave and call 911.
A dripping faucet
A drip is a routine repair. Submit a request. If water is also pooling under the sink, close both small valves under the sink by turning them clockwise.
Water that will not stop: close the water main, then call us. See Where are the water, power and gas shut-offs?
Power problems
This short video, by Skobel Homes, shows what a GFCI reset button and a tripped breaker look like. Then follow the steps below. Watch it on YouTube.
One outlet is dead
- Plug the same device into another outlet. If it works there, the device may be the problem, not the outlet.
- Press RESET on any GFCI outlet. A GFCI has TEST and RESET buttons. It is usually in a kitchen, bath, garage or outdoors. One GFCI can protect outlets in other rooms.
- Check the electrical panel for a tripped breaker. A tripped breaker sits in the middle, between on and off.
- Reset it once. Push it fully to off, then fully to on.
Part of the home has no power
Follow the same steps. Look first for a tripped breaker, which is the most likely cause, and for a GFCI outlet that has tripped. Reset a tripped breaker once.
The whole home has no power
- Look outside. If your neighbors’ lights are out too, it is probably an outage.
- If only your home is dark, check the panel for a tripped breaker, including the main breaker, and reset it once.
- Call your electric company if the power does not return. It is Columbia REA or Pacific Power, depending on where the home is. The number is on your bill. Ask whether there is an outage, and whether your service has been suspended.
Lights are not working
- Replace the bulb with the same type and size. Let a hot bulb cool first. Use a step stool if you need one, not a ladder.
- Check the breaker, and reset it once if it has tripped.
- If the light still does not work, or the fixture is too high to reach from a step stool, submit a request.
Stop and call us
- A breaker that trips again as soon as you reset it. Do not reset it a second time.
- Sparks, buzzing, or a burning smell at an outlet, a switch or the panel. Leave and call 911.
- Water reaching outlets, light fixtures or the panel, from a leak or flooding. Stay away and call 911.
Never open the panel’s inner cover, touch wiring, or replace a breaker or an outlet.
Heat and air
No heat, no cooling, or a blank thermostat
- Check the thermostat. It should be set to Heat or Cool. For heat, set it a few degrees above the room temperature. For cooling, set it a few degrees below.
- Replace the batteries if the screen is blank or dim.
- If the display shows an error or is frozen, switch it to Off for a minute, then back to Heat or Cool.
- Check the air filter. A clogged filter can shut the system down. Replace it if it has not been changed recently.
- Check any wall switch near the furnace, if there is one, to be sure it is on.
- Check that your gas or electric service is active. A suspended account stops the system. Call your utility if you are not sure.
- Give it a few minutes, then submit a request if it still does not run. Call us if it is freezing outside and you have no heat.
See Heating and cooling care for filters and thermostat settings.
Call 911
A gas smell, a carbon monoxide alarm, smoke or fire: leave first and take everyone with you. Then call 911 from outside. Never open a furnace panel or touch a pilot.
Appliances
The refrigerator is too warm, or freezing food
- Check the temperature dial or control. Set it a step colder if food is warm, or a step warmer if it is freezing.
- Check that the doors close fully and nothing blocks the seals.
- Check the grille at the bottom front for dust or blockage, and the small drain hole at the back of the refrigerator compartment for ice or food.
- Wait several hours for the temperature to settle. If food is still warm, submit a request the same day.
A range or oven will not heat
On an electric range, check the breaker and reset it once. On a gas range, do not use matches or a lighter, and do not keep trying. If you smell gas, leave and call 911. Otherwise submit a request.
A washer or dryer will not run
- Washer: make sure the door or lid is shut, a cycle is chosen and the breaker has not tripped. If it will not drain, do not open the door while it holds water. Submit a request.
- Dryer: make sure the door is shut and the lint filter is clean and pushed all the way in. Check the breaker and reset it once. If it runs but does not heat, or the top is very hot, stop using it and submit a request.
- Leaks: if a washer hose is leaking, close the valves behind the machine.
The garage door remote or opener does not work
Replace the remote’s battery. Check that the wall button works. Wipe the small sensor lenses near the floor on each side of the door and clear anything in the way. Never touch the springs, cables or brackets above the door. If it still fails, submit a request.
Your lease treats some items, such as a garbage disposal or a garage door opener, differently from the rest of the home. Check your lease, or call the office.
Doors and windows
A door or window sticks or will not lock
Do not force it, and do not change or add a lock. Changes to locks need written approval. Submit a request. If the home cannot be locked or secured, call us right away. If the cause was a break-in, report it to the police and then call us.
An alarm is chirping
A single chirp every minute or so usually means a low battery. Replace the battery in an alarm you can reach from the floor or a step stool. Many use a 9-volt battery. Press the test button afterward. Never remove or disable an alarm. If it keeps chirping, submit a request. If an alarm is sounding with smoke or fire, leave and call 911. See the alarm testing guide.
My problem is not on this list
Submit a request in the resident portal. A clear request is faster to act on.
- Log in to your resident portal.
- Go to the maintenance section.
- Say what is wrong, where in the home, and when it started.
- List what you already tried.
- Upload photos. Take a wide photo that shows the location and a close one of the problem. A ten-second video can help with a noise or a drip.
- Submit your request.
What happens after I submit?
A technician reviews each request and sorts it by urgency. We then contact you to arrange access and timing.
We will need to come into your home to make the repair, and we arrange that with you. Your lease and Washington law cover entry: RCW 59.18.150.
Who pays?
- Your lease says who pays for what. Check it, or call the office and we will go through it with you: (509) 525-1040.
- In general, we handle repairs to the home’s systems and normal wear. Residents are responsible for the everyday care on these pages and for damage that they or their guests cause.
- Please do not make or hire out repairs without our written approval. Submit a request instead.
Washington law Washington’s Residential Landlord-Tenant Act sets out a tenant’s duties (RCW 59.18.130) and a landlord’s duties (RCW 59.18.060).
Questions and answers
How many times should I reset a breaker?
Once. Push it fully to off, then fully to on. If it trips again, leave it off and submit a request. Sparks, buzzing or a burning smell mean leave and call 911.
Can I hire my own plumber or electrician?
No. Do not make or hire out repairs without our written approval. Submit a request instead.
What if I am not sure it is safe?
Stop and call us at (509) 525-1040. For a gas smell, smoke, fire or a carbon monoxide alarm, leave first and call 911.
How do I attach photos to a request?
Upload them in the resident portal when you describe the problem. Add a wide photo that shows where it is and a close one of the problem.
Last reviewed: .
This page is general information, not legal advice. The lease you signed and Washington law control. If anything here differs from your lease, your lease controls.