Home care
How do I stop mold, and when do I report it?
Prevent mold by running the bath fan, wiping wet surfaces and keeping air moving, and clean mold that grows on surfaces. If water is coming in from outside or from leaking plumbing, tell us at once and we handle it.
Key points
- Preventing mold and cleaning surface mold is the resident’s job.
- Run the fan during and after showers, wipe wet surfaces, and keep air moving.
- Your lease says when to tell us about mold or mildew.
- Water coming in from outside, or leaking plumbing, is reported at once. We handle the leak and the repair.
- Clean hard surfaces with detergent and water. Never mix cleaners, and never cut into drywall.
- Mold that covers a large area, is on drywall, carpet or ceiling tiles, or keeps coming back can mean a leak you cannot see. Report it so we can check for one.
Why does mold grow?
Mold needs moisture. It grows where a surface stays wet or damp, such as a shower, a window sill or a wall behind furniture. The Washington State Department of Health says mold problems in buildings are a result of water and moisture problems. Read its page on renters, landlords and mold.
Who does what?
Preventing mold is the resident’s job. That means:
- using exhaust fans in humid rooms,
- removing condensation from windows and other surfaces,
- keeping the home ventilated, and
- storing belongings so air can circulate.
Cleaning mold that grows on surfaces is the resident’s job too. The exception is water coming in from outside or from leaking plumbing. Report that at once, and we handle it.
Washington law Washington’s Residential Landlord-Tenant Act sets out a landlord’s duties (RCW 59.18.060) and a tenant’s duties (RCW 59.18.130).
What habits prevent mold?
- Use the bath fan during every shower and keep it on afterward until the steam clears. If there is no fan, open a window.
- Wipe wet surfaces. Squeegee or wipe the tub, shower walls and glass after use.
- Dry things out. Hang towels and bath mats so they dry. Do not leave wet clothes in a pile.
- Keep air moving. Leave the bathroom door open after a shower. Use the kitchen fan when you cook.
- Give walls room. Keep furniture a few inches away from outside walls, and keep closets from being packed tight.
- Keep vents clear. Do not block or cover a vent or register.
- Keep humidity down. The U.S. Environmental Protection Agency says to keep indoor humidity below 60 percent, and ideally between 30 and 50 percent. An inexpensive humidity meter from a hardware store will show the level in your home.
Keep tub and shower drains clear. See kitchen and laundry care for how.
Is window condensation normal?
Some fog on a window on a cold morning is normal. Wipe it off each day so water does not sit on the sill and frame. The Department of Health says renters need to run the heating and ventilation systems to reduce condensation.
Report it when:
- Water runs onto the sill or wall every day, even after you wipe it.
- You see dark spots on the frame, the sill or the wall around a window.
- Paint or wallboard near a window bubbles, peels or feels soft.
- A window is wet after rain and not only on cold mornings.
How do I clean small surface mold?
This is for mold on hard surfaces, such as tile, grout, a tub, a sealed window frame or a shower curtain.
- Protect yourself. Wear rubber gloves and eye protection. Run the fan or open a window.
- Scrub with detergent and water. The Environmental Protection Agency says to scrub mold off hard surfaces with detergent and water, and dry completely. A household cleaner used as its label says is fine.
- Dry the surface completely. Mold comes back on damp surfaces.
- Do not paint or caulk over mold. Painting and caulking are not resident jobs. If a stain will not clean off, tell us.
Never mix cleaners. Never mix bleach with ammonia or with any other cleaner. The fumes can be dangerous.
When to report it so we can check for a leak
- The growth covers a large area.
- It is on carpet, ceiling tiles, drywall or other soft material.
- It keeps coming back soon after you clean and dry it. That can mean a moisture problem you cannot see.
- You think it came from a leak or from sewage.
Never cut, tear open or pull apart drywall, a ceiling or flooring to look for mold.
What do I report right away?
Tell us at once about any of these.
- Water coming in from outside: a roof or window leak, a wet wall after rain, water at the foundation, or a ceiling stain.
- Leaking plumbing: a drip under a sink, around a toilet base, at a tub or shower, or from a pipe in a wall.
- A sewage smell or a drain that backs up.
- Drywall or a ceiling that is stained, soft or bubbling.
- A musty smell with no source you can find.
- Carpet that is wet from any source.
Report these in the resident portal, so the request is in writing and you can add photos.
How to report it
- If water is running, close the water main first. See the shut-offs page.
- Take photos of the spot, and one wider photo that shows where it is.
- Submit a maintenance request in the resident portal.
- Say where it is, when you first saw it, and whether it gets worse after rain or after you run water.
What happens next
We look for the source and handle the repair. We will coordinate access and scheduling directly with you.
Stop and call us
- A leak you cannot stop, or water coming in from outside.
- A ceiling that is stained, sagging or dripping.
- A sewage smell or a drain backing up.
- A large area of growth, or growth that returns after you clean it.
Call (509) 525-1040, Monday to Friday, 9:00 AM to 4:00 PM. For after-hours property emergencies, use the same number and see our emergency page.
Call 911
Water pouring in near outlets, lights or the electric panel: leave the area first and call 911, then call the office.
Who pays?
A leak from outside or from plumbing is ours to fix. If the problem came from your misuse or neglect, changes you made to the home, or equipment you own, it is the resident’s responsibility. Your lease explains how that works.
What about moldy caulk?
Clean mold on caulk as described above. If caulk is cracked, peeling or black all the way through, tell us. Do not re-caulk it yourself.
Questions and answers
Who cleans mold?
You do, for mold that grows on surfaces. The exception is water coming in from outside or leaking plumbing. Report that at once and we handle it.
Can I use bleach?
Detergent and water works on hard surfaces. Whatever you use, follow its label, and never mix bleach with ammonia or any other cleaner.
When do I tell you about mold?
Your lease says when. Always report a leak, water coming in from outside, or mold that keeps coming back.
Who pays for mold?
A leak from outside or from plumbing is ours to fix. If the cause was your misuse, neglect or changes to the home, it is the resident’s responsibility.
Last reviewed: .
This page is general information, not legal advice. The lease you signed and Washington law control. If anything here differs from your lease, your lease controls.