Also here for your property? Property Owners →

Home care

How do I test my smoke and carbon monoxide alarms, and what if one chirps?

Test each alarm once a month with its test button, and replace the battery when an alarm chirps. If a smoke alarm sounds continuously, or any carbon monoxide alarm goes off, leave the home and call 911. Never remove or disable an alarm.

Key points

  • The owner installs smoke alarms. Residents test them, replace batteries and report problems. Your lease has the details.
  • Carbon monoxide alarms are looked after the same way.
  • Report an alarm that fails, is missing or is damaged the same day, through the resident portal.
  • A short chirp usually means the battery is low. If it keeps chirping after a new battery, report it the same day.
  • Never remove, cover, paint or disable an alarm, and never take out its battery and leave it out.
  • Do not use a ladder. If you cannot reach an alarm from the floor or a step stool, submit a request.

Call 911

Smoke, fire, a continuous smoke alarm, a gas smell or any carbon monoxide alarm: get everyone out, including pets, then call 911 from outside. Do not go back in.

Who does what?

The owner installs the smoke alarms. Residents test them, replace batteries and report any problem. Carbon monoxide alarms work the same way. Your lease has the details, and the office will go through them with you.

Washington law State law makes the owner responsible for installing smoke detection devices. It makes the tenant responsible for maintaining them, including replacing batteries (RCW 43.44.110).

Washington law Washington law covers carbon monoxide alarms in rentals: RCW 19.27.530.

Look for the alarms in the hallways near the bedrooms and on each floor. If you cannot find one, ask the office.

What type of alarm do I have?

Alarms come in three common types. The label on the alarm says which one you have, and it also gives the maker’s instructions.

  • Battery only. It has a battery door or a battery you can see. You replace the battery.
  • Hard-wired with a backup battery. It is wired to the house. You replace only the backup battery.
  • Sealed with a built-in battery. The label gives a set number of years. When it chirps, the whole alarm is replaced, and you submit a request.

If you cannot tell which you have, ask the office.

How do I test an alarm?

  1. Warn the household. The alarm is loud.
  2. Press and hold the test button until the alarm sounds. Some units need a few seconds.
  3. Listen. A good test is a loud, steady alarm. A weak sound, a short sound or no sound is a failed test.
  4. If it fails, replace the battery and test again. If it still fails, submit a maintenance request the same day.

Test every smoke and carbon monoxide alarm once a month.

What does a chirp mean?

A short chirp every minute or so usually means the battery is low. Some alarms also chirp when they reach the end of their life. The maker’s instructions on the label tell you which signal is which.

How to replace a battery

  1. Reach it safely. Use the floor or a step stool only. If you need a ladder, submit a request instead.
  2. Open it the way the label shows. Many twist off the ceiling plate, or have a battery door.
  3. Swap the battery for the type the alarm lists. Many take a 9V battery.
  4. Close it and press the test button.

On a hard-wired alarm, change only the backup battery. Do not unplug the wiring or touch wires.

If it keeps chirping

Look at the date printed on the back of the alarm. An alarm that chirps after a new battery, or that is past its date, needs replacing. Submit a maintenance request the same day. Do not leave it unplugged or without a battery.

What if my smoke alarm goes off while I cook?

  • Turn on the kitchen fan and open a window or door.
  • Wave a towel under it to move the air.
  • Never cover it, pull its battery or disable it.
  • If it goes off often with no cause, submit a maintenance request.

If you cannot tell whether it is cooking or a real fire, treat it as a fire. Leave and call 911.

What does a carbon monoxide alarm mean?

Carbon monoxide is a gas you cannot see or smell. A carbon monoxide alarm means it may be in the air. Sources include a generator, a grill, a fuel-burning heater, a car running in a garage, or a gas appliance that is not working right.

  1. Get everyone outside to fresh air, including pets.
  2. Call 911 from outside.
  3. Stay out until the fire department says it is safe.
  4. Then call the office at (509) 525-1040.

On a carbon monoxide alarm, the alarm and the low-battery chirp sound different. The label shows the difference. If you are not sure which one you hear, treat it as an alarm: go outside and call 911.

How to prevent it

  • Never run a generator, grill, camp stove or fuel-burning heater indoors or in a garage.
  • Never run a car or truck in a garage, even with the garage door open.
  • Never heat the home with the oven or the stove.
  • Keep snow and leaves away from furnace, water heater and dryer vents on the outside walls. See snow and ice.

What if an alarm is missing or damaged?

Tell us the same day. Submit a maintenance request in the resident portal, and say which room the alarm is in. If you move in and an alarm does not work, tell us the same way.

Never remove, cover, paint or disable an alarm. Washington law covers smoke detection devices (RCW 43.44.110), and your lease explains your part.

Report the same day

  • An alarm that keeps chirping after you put in a new battery. Report it the same day.
  • An alarm that fails its test, is missing, or is damaged. Report it the same day.
  • A sealed alarm that chirps. It needs to be replaced.

Submit a request in the resident portal the same day. If you cannot use the portal, call (509) 525-1040, Monday to Friday, 9:00 AM to 4:00 PM.

Submit a maintenance request

Questions and answers

Who replaces the battery in my smoke alarm?

You do. State law makes the owner responsible for installing smoke alarms and the tenant responsible for maintaining them, including replacing batteries.

How often do I test my alarms?

Once a month. Press the test button on each smoke and carbon monoxide alarm.

My alarm still chirps after a new battery. What now?

Submit a maintenance request the same day. The alarm may be at the end of its life and need replacing.

What do I do if a carbon monoxide alarm goes off?

Get everyone outside, including pets, and call 911 from outside. Stay out until the fire department says it is safe.

Can I take the battery out when cooking sets it off?

No. Use the fan and open a window. Never cover, remove or disable an alarm.

Last reviewed: .

This page is general information, not legal advice. The lease you signed and Washington law control. If anything here differs from your lease, your lease controls.